Full Ceramic Crowns and Bridges Although the aesthetically pleasing porcelain veneers are tried to be made aesthetically, the light is reflected back on the surface of the porcelain veneer and prevents the transmission of light to the gum of the tooth. This may result in a more artificial appearance than natural teeth and, in particular, shading in the gingival region of the anterior teeth. Porcelain Inlays [Porcelain fillings] Porcelain is the most compatible material with teeth and gums. In addition, since coloration is not observed in porcelain inlays after a certain period of time in composite fillings, inlays retain their aesthetic and protective properties for many years from the moment they were made. Artificial teeth in exaggerated forms and colors, far from naturalness, are immediately recognized by an amateur eye at first glance. Therefore, a rigorous preparation and planning phase is required in esthetic dentistry.
Clinical and Radiological Examination: A general oral and dental examination is carried out to evaluate the oral and dental health before going on to aesthetic solutions. It is decided to follow the path by taking all the mouth rhombus (panoramic x-ray) of the patient. Model: Measurements of upper and lower jaw are obtained and the model of teeth and surrounding tissues is obtained. Evaluation is made on the models. Photographing: Face, smile, profile and mouth photographs are taken from each angle. Planning: The aesthetically problematic areas of the teeth and gums on the photos and models taken from the patient are evaluated by considering the whole face region. Treatment Methods Gingivectomy [Regulation of Gingival Levels] When we laugh, we often come across situations where the gums are overly visible or the gums are asymmetrical because of the short tooth colors. In such cases, the gingival diseases can be extended with the intervention of the specialists or the gums can be made symmetrical. After the gum fit is achieved, it is possible to perform various aesthetic arrangements in the teeth with the interventions of the prosthesis specialists. Whitening Dental color may be applied in patients who are darkly born or subsequently have teeth color yellowing for various reasons. It is applied in two ways: Home [home] type: A special gel light device, which is applied to the teeth after isolation of the gums in the clinical setting, is activated. Office (clinical) type: After isolation of the gums in a clinical setting, a special gel light is applied to the teeth. Laminate Vener Crowns [Leaf Porcelain] Unlike conventional prosthesis applications, it is sufficient to make only slight abrasions from the front of the tooth without reducing the entire tooth. Smile Design If a comprehensive treatment is needed to eliminate the existing aesthetic problems, necessary consultation is made with the gingival diseases and orthodontics specialists. A new smile is applied to the face and lip structure in line with the expectations of the patient. The smile can be shown to the patient with the measurements taken from the mouth and the models designed in laboratory environment. In this way, the patient can see the initial state of the people who have experienced similar problems and the results obtained after the treatment.